Instrument Function
R&S
®
SMBV100A
123Operating Manual 1176.8016.02 ─ 17
5.2.3.3 Software / Options
The "Software/Options" dialog shows the firmware version of the instrument software
and all installed hardware and software options.
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option.
How to install options is described in chapter 4 "Software Update / Installing Options"
of the service manual.
The installation of hardware options purchased at a later stage is also described in the
service manual. Most hardware options need to be installed at an authorized
Rohde&Schwarz service shop.
To access the "Software/Options" dialog, select "System" and press the SETUP or
MENU key.
The menu is divided into the following sections:
●
"Firmware"
●
"Hardware Options"
●
"Software Options"
●
"WinIQSIM"
●
"Loaded Modules"
Firmware
The firmware section of the menu shows the firmware version and the version of the
software platform.
Note: Your instrument is delivered with the latest firmware version available. Firmware
updates and the "Release Notes" describing the improvements and modifications are
provided on the Internet at the download site of the Rohde & Schwarz signal generator
General Instrument Settings
To Next Page
Loading...
