Rohde & Schwarz SMBV100A - Source:iq:output Subsystem

Remote Control Commands
R&S
®
SMBV100A
749Operating Manual 1176.8016.02 ─ 17
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
IQ:SWAP ON
swaps the I and Q channel.
Manual operation: See "I/Q-Swap - I/Q Mod" on page 301
[:SOURce<hw>]:IQ:WBSTate <WbState>
Selects optimized setting for wideband modulation signals (>5 MHz) (State ON).
Parameters:
<WbState> 0 | 1 | OFF | ON
*RST: 0
Example:
IQ:WBST ON
activates optimized setting for wideband signals.
Manual operation: See "I/Q-Wideband - I/Q Mod" on page 301
7.16.10 SOURce:IQ:OUTput Subsystem
7.16.10.1 Analog I/Q Outputs
This subsystem contains the commands for configuring the differential output.
For information about the required options, see Chapter 5.7.3.2, "Analog I/Q Output",
on page 316.
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe].........................................749
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:I................................................................... 750
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q................................................................. 750
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:I............................................................... 750
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:Q..............................................................750
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:OPTimization[:RF]:STATe...............................750
[:SOURce<hw>]:IQ:OUTPut:LEVel.................................................................................. 751
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:POWer:PEP:RESult?............................................. 751
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:MODE...................................................................751
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:POWer:DATTenuation............................................752
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE....................................................................752
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe] <State>
Couples the bias setting of the I and Q signal components.
If coupling is activated, settings made for the I-signal component ([:SOURce<hw>]:
IQ:OUTPut[:ANALog]:BIAS:I) automatically applies to the Q-signal ([:
SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q)
SOURce Subsystem