Rohde & Schwarz SMBV100A - Source Subsystem; Source:am Subsystem

Remote Control Commands
R&S
®
SMBV100A
589Operating Manual 1176.8016.02 ─ 17
7.16 SOURce Subsystem
The SOURce subsystem contains the commands for configuring the digital and analog
signals.
SOURce<hw>
For one-path instruments, the keyword SOURce is optional and can be omitted.
● SOURce:AM Subsystem.......................................................................................589
● SOURce:AWGN Subsystem.................................................................................591
● SOURce:BB Subsystem....................................................................................... 599
● SOURce:BBIN Subsystem....................................................................................716
● SOURce:CORRection Subsystem........................................................................722
● SOURce:FM Subsystem.......................................................................................731
● SOURce:FREQuency Subsystem.........................................................................734
● SOURce:INPut Subsystem................................................................................... 742
● SOURce:IQ Subsystem........................................................................................ 746
● SOURce:IQ:OUTput Subsystem...........................................................................749
● SOURce:LFOutput Subsystem............................................................................. 757
● SOURce:LIST Subsystem.....................................................................................767
● SOURce:MODulation Subsystem......................................................................... 780
● SOURce:PGEN Subsystem..................................................................................780
● SOURce:PHASe Subsystem................................................................................ 781
● SOURce:PM Subsystem.......................................................................................782
● SOURce:POWer Subsystem................................................................................ 785
● SOURce:PULM Subsystem.................................................................................. 796
● SOURce:ROSCillator Subsystem......................................................................... 803
● SOURce:SWEep Subsystem................................................................................806
7.16.1 SOURce:AM Subsystem
The AM subsystem contains the commands for setting the amplitude modulation.
An external modulation signal is input at the EXT MOD connector.
The settings for the internal modulation source (LF generator) are made in the
SOURce:LFOutput subsystem.
[:SOURce<hw>]:AM[:DEPTh]..........................................................................................589
[:SOURce<hw>]:AM:EXTernal:COUPling......................................................................... 590
[:SOURce<hw>]:AM:SENSitivity?.................................................................................... 590
[:SOURce<hw>]:AM:SOURce......................................................................................... 591
[:SOURce<hw>]:AM:STATe............................................................................................ 591
[:SOURce<hw>]:AM[:DEPTh] <Depth>
Sets the modulation depth of the amplitude modulation signal in percent.
SOURce Subsystem