Rohde & Schwarz SMBV100A - Hard Copy Options; Hard Copy Settings

Instrument Function
R&S
®
SMBV100A
156Operating Manual 1176.8016.02 ─ 17
5.2.5.1 Hard Copy Settings
► To access the dialog, press the HCOPY key.
The dialog contains the parameters for configuring the output format and location
of a hard copy.
The remote commands required to define the hard copy settings are described in
Chapter 7.11, "HCOPy Subsystem", on page 556.
Options
Opens the "Hard Copy Options" dialog for configuring the corresponding parameters
(see " File Options " on page 157.
Remote command:
n.a.
File
Some configuration parameters are already offered in the "Hard Copy" dialog. All con-
figuration parameters are available in " File Options " on page 157.
Automatic Naming
Activates automatic generation of the file name. Automatic naming is configured in the
"Options…" sub dialog , see " File Options " on page 157.
Remote command:
:HCOPy:FILE[:NAME]:AUTO:STATe on page 561
File Info
Indicates the file name. The file name can be entered either manually via the file man-
ager (button "File…") or generated automatically (Automatic naming checkbox). Auto-
matic naming is configured in the "Options…" submenu.
Remote command:
:HCOPy:FILE[:NAME] on page 558
:HCOPy:FILE[:NAME]:AUTO:FILE? on page 559
5.2.5.2 Hard Copy Options
This section describes the "Hard Copy Options" dialog.
General Instrument Settings