Rohde & Schwarz SMBV100A - Settings Displayed in the Header Section

Manual Operation
R&S
®
SMBV100A
82Operating Manual 1176.8016.02 ─ 17
Figure 4-1: Block diagram of a fully equipped R&S SMBV
The latest R&S SMBV Vector Signal Generators are equipped with a new version of
the base board, which shows the block diagram in slightly different shapes, see Chap-
ter 2.1.3, "Display", on page 22. The functionality does not change.
4.2.1 Settings Displayed in the Header Section
Frequency/level settings and a few status messages (see Chapter 4.2.2, "Status Infor-
mation and Messages", on page 83) are displayed in the header field of the screen.
The display may vary depending on the instrument's operating mode:
●
In the sweep mode, the current frequency or level of the output signal is displayed.
The status message "SweepMode" is displayed in the info line.
●
In the list mode, neither the current frequency nor level is displayed, the indication
is dimmed.
●
If user correction is active, the status message "UCorr" is displayed in the info line.
●
In the case of digital modulation, "Freq" indicates the frequency, "PEP" the peak
envelope power and "Level" the average level.
The values displayed in the "Freq" and "Level" fields include a set offset or multiplier
factor.
See also "RF Frequency and Phase" and "RF Level" in the Operating Manual.
Display