Rohde & Schwarz SMBV100A - Table of Contents

Remote Control Commands
R&S
®
SMBV100A
533Operating Manual 1176.8016.02 ─ 17
:BLER:SETup:CORDer...................................................................................................537
:BLER:SETup:DATA[:POLarity]....................................................................................... 538
:BERT:SETup:DATA[:POLarity]....................................................................................... 538
:BLER:SETup:DATA:CONNector.....................................................................................538
:BERT:SETup:DATA:CONNector.....................................................................................538
:BLER:SETup:DENable.................................................................................................. 539
:BERT:SETup:DENable.................................................................................................. 539
:BERT:SETup:IGNore.....................................................................................................539
:BLER:SETup:MCOunt................................................................................................... 540
:BERT:SETup:MCOunt...................................................................................................540
:BLER:SETup:MERRor...................................................................................................540
:BERT:SETup:MERRor...................................................................................................540
:BERT:SETup:RESTart[:STATe]......................................................................................541
:BERT:SETup:TYPE.......................................................................................................541
:BLER:SETup:TYPE.......................................................................................................541
:BLER:SETup:TIMeout................................................................................................... 542
:BERT:SETup:TIMeout................................................................................................... 542
:BLER:STARt................................................................................................................ 542
:BERT:STARt................................................................................................................ 542
:BLER:STATe................................................................................................................542
:BERT:STATe................................................................................................................542
:BLER:STOP................................................................................................................. 543
:BERT:STOP.................................................................................................................543
:BLER:UNIT.................................................................................................................. 543
:BERT:UNIT.................................................................................................................. 543
[:SOURce]:INPut:BERT:IMPedance.................................................................................543
[:SOURce]:INPut:BERT:THReshold................................................................................. 544
:TRIGger:BLER[:IMMediate]............................................................................................544
:TRIGger:BERT[:IMMediate]............................................................................................544
:BERT|BLER:LOAD <Filename>
Loads the selected BERT/BLER settings file from the default or the specified directory.
Loaded are files with extension *.ber_bler.
Setting parameters:
<Filename> string
Filename or complete file path
Usage: Setting only
:BERT|BLER:PRESet
Sets the parameters of the BERT/BLER test generator to their default values.
Usage:
Event
BERT and BLER Subsystems