Remote Control Commands
R&S
®
SMBV100A
642Operating Manual 1176.8016.02 ─ 17
Parameters:
<Mode> UNCHanged | ERMS
UNCHanged
The segments are output exactly as defined in the files.
ERMS
The segments are output so that all segments have the same
rms value.
*RST: UNCHanged
Example:
BB:ARB:WSEG:CONF:LEV:MODE UNCH
selects level mode unchanged. The segments are output as
defined in the waveform file.
Manual operation: See " Level " on page 415
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
<Mode>
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
Parameters:
<Mode> OFF | MRK1 | MRK2 | MRK3 | MRK4
OFF
No additional marker is generated.
MRK1|MRK2|MRK3|MRK4
Generates a restart marker signal at the beginning of each seg-
ment for the corresponding marker.
The segment begin is defined by the low-high slope of the
marker. This applies for switching between two segments as
well as in case of segment replay.
*RST: OFF
Example:
BB:ARB:WSEG:CONF:SEL 'ConfComm'
BB:ARB:WSEG:CONF:MARK:ESEG MRK3
Manual operation: See " Segment Restart " on page 417
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
<Mode>
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
SOURce Subsystem
To Next Page
Loading...
