Rohde & Schwarz SMBV100A - Instrument Emulations

Instrument Function
R&S
®
SMBV100A
144Operating Manual 1176.8016.02 ─ 17
Baud Rate ← RS232 using USB adapter
Sets the baudrate for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:BAUD on page 832
Parity ← RS232 using USB adapter
Sets the parity for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:PARity on page 833
Stop Bits ← RS232 using USB adapter
Sets the number of stop bits for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:SBITs on page 833
Visa Resource Strings
Displays the visa resource strings, used for remote control of the instrument. Each
interface requires an individual unique address, to identify the instrument for remote
control.
Remote command:
:SYSTem:COMMunicate:HISLip:RESource? on page 832
:SYSTem:COMMunicate:NETWork:RESource? on page 831
:SYSTem:COMMunicate:SOCKet:RESource? on page 833
:SYSTem:COMMunicate:GPIB:RESource? on page 831
:SYSTem:COMMunicate:USB:RESource? on page 832
:SYSTem:COMMunicate:SERial:RESource? on page 832
Goto Local
Switches the instrument to operate in local control mode.
Switching from remote to local control mode can be also done with one of the following
actions:
●
manually with the LOCAL key on the front panel
●
with the interface command &GTL via the remote control interface
●
with the key combination CTRL + Q.
Remote command:
&GTL
5.2.3.16 Instrument Emulations
It is also possible to remotely control the R&S SMBV via the command set of another
signal generator, as for example of an HP generator. With this function you can, for
example, replace a signal generator with an R&S SMBV in an automated test setup,
without adjusting the command scripts used. You find all the remote control command
sets supported by the R&S SMBV in a selection list.
General Instrument Settings