Rohde & Schwarz SMBV100A - Global Trigger;Clock;External Input Settings

Instrument Function
R&S
®
SMBV100A
139Operating Manual 1176.8016.02 ─ 17
Default Gateway
Displays the gateway address.
To assign the gateway address manually, select Address Mode "Static".
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway on page 830
DNS Suffix
Displays the primary DNS (Domain Name System) suffix, that means the DNS name
without the host name part.
The DNS system uses the suffix for registration and name resolution to uniquely iden-
tify the instrument in the entire network.
To assign the DNS suffix manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:DOMain on page 828
DNS Server
Determines the preferred server for name resolution. The DNS server contains the
underlying numerical values that are required for name resolution of the host name as
part of the IP address.
To select the DNS server manually, select Address Mode "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:DNS on page 829
MAC Address
Indicates the MAC (Media Access Control) address, a unique identifier of the network
adapter in the R&S SMBV.
Remote command:
:SYSTem:COMMunicate:NETWork:MACaddress on page 830
Restart Network
Terminates the network connection to the instrument and subsequently re-establishes
it.
Used this function to resolve network problems.
Note: Only the connection of the instrument to the network restarts, the network itself
is not affected.
Remote command:
:SYSTem:COMMunicate:NETWork:RESTart on page 831
5.2.3.13 Global Trigger/Clock/External Input Settings
The "Global Trigger/Clock/External Inputs" menu can be opened using the SETUP or
MENU key under the "Setup" menu as well as in all clock and trigger menus of the
"Baseband" function block.
General Instrument Settings