Remote Control Commands
R&S
®
SMBV100A
829Operating Manual 1176.8016.02 ─ 17
Note: it is recommended that you do not change the host name in order to avoid prob-
lems with the networdk connection. However, if you change the host name be sure to
use an unique name.
The host name is a protected parameter, To change it, first disable protection level 1
with command :SYSTem:PROTect<ch>[:STATe] on page 836.
Parameters:
<Hostname> string
Example:
SYSTem:PROTect1:STATe OFF,123456
SYSTem:COMMunicate:NETWork:HOSTname 'SIGGEN'
sets the individual computer name of the R&S SMBV.
Manual operation: See "Hostname" on page 137
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup <Workgroup>
Sets the individual workgroup name of the instrument.
Parameters:
<Workgroup> string
Example:
SYSTem:COMMunicate:NETWork:COMMon:WORKgroup
'TEST_09'
sets the workgroup name
Manual operation: See "Workgroup" on page 138
:SYSTem:COMMunicate:NETWork[:IPADdress]:DNS <DNS>
Determines the net DNS server to resolve the name.
Parameters:
<DNS> string
Example: SYST:COMM:NETW:IPAD:DNS 123.456.0.1
Manual operation: See "DNS Server" on page 139
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
Selects manual or automatic setting of the IP address.
Parameters:
<Mode> AUTO | STATic
*RST: n.a. (factory preset: AUTO)
Example:
SYSTem:COMMunicate:NETWork:IPADdress:MODE AUTO
The IP address is assigned automatically (DHCP)
Manual operation: See "Address Mode" on page 138
SYSTem Subsystem
To Next Page
Loading...
