Instrument Function
R&S
®
SMBV100A
164Operating Manual 1176.8016.02 ─ 17
Recall
Loads the selected configuration.
If an instrument setting in which a sweep was activated is saved, the sweep starts
when the recall command is called.
If an instrument setting which accesses lists is saved, this list is also loaded.
If the list has been deleted in the meantime, an error message appears when the
instrument setting is loaded. If the list has been overwritten in the meantime, the new
entries will be used.
Remote command:
:MMEMory:LOAD:STATe on page 573
:SYSTem:RCL on page 827
Refer to the descriptions of the firmware options for the correct syntax of the corre-
sponding SCPI command:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:LOAD
Recall Immediate x
Loads the selected configuration from one of the three intermediate memories.
If an instrument setting in which a sweep was activated is saved, the sweep is started
when the recall command is called.
If an instrument setting which accesses lists is saved, this list is also loaded.
If the list has been deleted in the meantime, an error message appears when the
instrument setting is loaded. If the list has been overwritten in the meantime, the new
entries will be used.
A message appears if no instrument configuration is saved in this memory.
Remote command:
*RCL on page 507
File Manager
Accesses the "File Manager" dialog, see Chapter 5.2.8.5, "File Manager",
on page 166.
Remote command:
n.a.
5.2.8.4 File Select Dialog
The "File Select" dialog opens automatically each time you select a data list file as data
source or you select a control list.
To access a loadable data list file
1. Select the "Data List Name" in the individual dialog, e.g. for "Baseband > 3GPP
FDD > Basestations > BS1 > Channel Table > P-CCPCH > Data = Data List"
select "DList = None".
A "File Select" dialog for loading, creating and modifying a file is displayed.
General Instrument Settings
To Next Page
Loading...
