Rohde & Schwarz SMBV100A - Display Subsystem

Remote Control Commands
R&S
®
SMBV100A
551Operating Manual 1176.8016.02 ─ 17
:DIAGnostic:INFO:OTIMe?
The command queries the number of operation hours.
Return values:
<OTIMe> float
Example:
DIAG:INFO:OTIM
queries the operation hours.
Response: 100023
The instrument was operated for 100023 hours up to now.
Usage: Query only
Manual operation: See "Operation Time / h" on page 122
:DIAGnostic:INFO:POCount?
The command queries the number of power-on events.
Return values:
<Pocount> float
Example:
DIAG:INFO:POC
queries the number of power on events.
Response: 123
The instrument was switched on for 123 times up to now.
Usage: Query only
Manual operation: See "Power On Count" on page 122
7.9 DISPlay Subsystem
The DISPlay subsystem contains the commands to set the power-save mode of the
instrument.
:DISPlay:ANNotation:AMPLitude..................................................................................... 551
:DISPlay:ANNotation:FREQuency....................................................................................552
:DISPlay:ANNotation[:ALL]..............................................................................................552
:DISPlay:DIALog:CLOSe................................................................................................ 552
:DISPlay:DIALog:CLOSe:ALL..........................................................................................552
:DISPlay:DIALog:ID?...................................................................................................... 553
:DISPlay:DIALog:OPEN..................................................................................................553
:DISPlay:PSAVe:HOLDoff...............................................................................................553
:DISPlay:PSAVe[:STATe]................................................................................................553
:DISPlay:UPDate........................................................................................................... 554
:DISPlay:ANNotation:AMPLitude <State>
Indicates asterisks instead of the level values in the status bar.
DISPlay Subsystem