Rohde & Schwarz SMBV100A - Page 567

Remote Control Commands
R&S
®
SMBV100A
552Operating Manual 1176.8016.02 ─ 17
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 1)
Example:
DISP:ANN:AMPL ON
Suppresses the level display.
Manual operation: See "Annotation Amplitude" on page 151
:DISPlay:ANNotation:FREQuency <State>
Indicates asterisks instead of the frequency values in the status bar.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 1)
Example:
DISP:ANN:FREQ ON
Supresses the frequency display.
Manual operation: See "Annotation Frequency" on page 151
:DISPlay:ANNotation[:ALL] <State>
Displays asterisks instead of the level and frequency values in the status bar of the
instrument. This setting is useful when you remotely control the instrument.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:AMPL ON
Shows asterisks instead of frequency and level values.
:DISPlay:DIALog:CLOSe <DialogId>
Closes the specified dialog. To determine the dialog identifier, use command :
DISPlay:DIALog:ID?.
Setting parameters:
<DialogId> string
Example:
DISP:DIAL:CLOS "<dialog ID>"
Closes the dialog, determined with the "<dialog ID>".
Usage: Setting only
:DISPlay:DIALog:CLOSe:ALL
Closes all open dialogs.
Example:
DISP:DIAL:CLOS:ALL
DISPlay Subsystem