Rohde & Schwarz SMBV100A - Keys for Setting Parameters; Setup Keys

Preparing for Use
R&S
®
SMBV100A
24Operating Manual 1176.8016.02 ─ 17
For detailed information, see Chapter 4.2, "Display", on page 81.
2.1.4 Setup Keys
The keys to the right of the display set parameters, select views and control the win-
dows.
2.1.4.1 Keys for Setting Parameters
These keys provide direct access to the settings in the header of the instrument and
can be used for fast changing the state of the modulation and the RF signal.
For more information refer to chapter "Instrument Functions" in the Operating Manual.
FREQ
Activates frequency entry.
RF ON/OFF
Switches the RF signal on and off.
"RF OFF" is displayed in the header next to the "Frequency" field.
LEVEL
Activates level entry.
MOD ON/OFF
Switches the modulations on and off.
"MOD OFF" is displayed in the info line of the header next to the "Level" field.
FILE
Activates the menu for storing or loading files (see Chapter 4.7, "File Management",
on page 105).
RECALCULATE
Starts the recalculation of instrument settings.
If time-consuming calculations are required, the active modulation is automatically
switched off and the calculation is interrupted to allow the user to make further settings.
Calculation is restarted by a keystroke and the modulation is switched on again after
the calculation is completed.
Front Panel Tour