Rohde & Schwarz SMBV100A - [:Source<Hw>]:Bb:arbitrary:wsegment:create; [:Source<Hw>]:Bb:arbitrary:wsegment:name

Remote Control Commands
R&S
®
SMBV100A
645Operating Manual 1176.8016.02 ─ 17
Parameters:
<Filename> string
Example:
MMEM:CDIR '/var/user/waveform'
sets the default directory.
BB:ARB:WSEG:CONF:SEL 'new'
create configuration file new.inf_mswv in the default directory.
Manual operation: See " Load List " on page 418
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
<FilenameInput>
Creates a multi segment waveform using the current settings of the specified configu-
ration file. The multi segment waveform is saved into the file defined in the configura-
tion file. The file extension is *.wv.
Setting parameters:
<FilenameInput> string
Example:
MMEM:CDIR '/var/user/'
sets the default directory
BB:ARB:WSEG:CONF:SEL 'new'
creates the configuration file new.inf_mswv in the default
directory.
BB:ARB:WSEG:CONF:SEGM:APP 'arb1.wv'
'includes waveform arb1.wv as segment 1 in the configuration
file. The waveform must be available in the default directory.
BB:ARB:WSEG:CONF:OFIL 'multi_wv1'
defines the file name multi_wv1.wv for the multi segment
waveform.
BB:ARB:WSEG:CRE '/var/user/new.inf_mswv'
creates multi segment waveform multi_wv1.wv using the set-
tings of the configuration file new.inf_mswv.
Usage:
Setting only
Manual operation: See " Save List " on page 418
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NAME?
This command queries the name of the waveform of the currently output segment of
the multi segment waveform.
Return values:
<Name> string
Example:
BB:ARB:WSEG:NAME?
queries the currently output segment.
Usage: Query only
Manual operation: See "Current Segment" on page 394
SOURce Subsystem