Rohde & Schwarz SMBV100A - Test Signals Settings

Remote Control Commands
R&S
®
SMBV100A
615Operating Manual 1176.8016.02 ─ 17
Test Signals Settings
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate......................................................... 615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate.............................................. 615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate....................................................... 615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed............................................. 615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed.................................. 615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed............................................615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I....................................................................615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q.................................................................. 615
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:AMPLitude..........................................616
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:FREQuency........................................616
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:OFFSet.............................................. 616
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:SAMPles............................................ 617
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency................................................. 617
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe........................................................ 617
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles..................................................... 618
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate
Generates a signal and uses it as output straight away.
Example:
BB:ARB:TSIG:SINE:CRE
generates a test sine signal and uses it as output straight away.
Usage: Event
Manual operation: See "Generate Signal RAM (Sine Test Signal)" on page 405
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed <Filename>
Generates a signal and saves it to a waveform file.
Setting parameters:
<Filename> string
Example:
BB:ARB:TSIG:SINE:CRE:NAM 'sine_test'
generates a test sine signal and saves it into the wavefile
sine_test.
Usage: Setting only
Manual operation: See "Generate Signal HD (Sine Test Signal)" on page 405
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I <I>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q <TSig>
Sets the value for the I/Q component of the test signal
SOURce Subsystem