Rohde & Schwarz SMBV100A - Page 631

Remote Control Commands
R&S
®
SMBV100A
616Operating Manual 1176.8016.02 ─ 17
Parameters:
<TSig> float
Range: -1 to 1
Increment: 0.001
*RST: 0
Default unit: FS
Example:
BB:ARB:TSIG:CIQ:Q 0.5
sets the value for the Q component of the test signal.
Manual operation: See "Q Value (Const IQ Test Signal)" on page 406
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:AMPLitude <Amplitude>
Sets the digital amplitude of the rectangular wave.
Parameters:
<Amplitude> float
Range: 0 to 1
Increment: 0.001
*RST: 0.800
Default unit: FS
Example:
BB:ARB:TSIG:RECT:AMPL 0.5
sets the amplitude of the test signal
Manual operation: See "Amplitude (Rect Test Signal)" on page 405
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:FREQuency <Frequency>
Sets the frequency of the test signal.
Parameters:
<Frequency> float
Range: 100 to depends on hardware
Increment: 0.01
*RST: 1000
Example:
SOURce:BB:ARBitrary:TSIGnal:RECTangle:FREQuency
100 kHz
sets the frequency of the test signal of 100 kHz.
Manual operation: See "Frequency (Rect Test Signal)" on page 405
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:OFFSet <Offset>
Sets the DC component.
SOURce Subsystem