EasyManua.ls Logo

Rohde & Schwarz SMBV100A - Trigger Subsystem

Rohde & Schwarz SMBV100A
911 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Control Commands
R&S
®
SMBV100A
843Operating Manual 1176.8016.02 ─ 17
:TEST:BB:DATA:TYPE <Type>
Selects the measurement mode of the BER/BLER test generator.
Parameters:
<Type> BER | BLER
*RST: BER
7.20 TRIGger Subsystem
The TRIGger system contains the commands for selecting the trigger source for the
RF and LF sweep. The trigger input connectors are configured in the SOURce:INPut
subsystem.
The trigger system of the R&S SMBV is a simplified implementation of the SCPI trigger
system. The TRIGger system differs from the SCPI system as follows:
No INITiate command; the instrument behaves as if INITiate:CONTinuous
ON were set.
Under TRIGger several sweep subsystems exist.
Other commands associated with the trigger system of the R&S SMBV can be found in
the modulation and RF signal subsystems.
TRIGger<hw>
Suffix TRIGger<1|2> is not permitted
TRIGger0 activates the LF output.
Table 7-3: Cross-reference between the manual and remote control
R&S name SCPI name Command under manual con-
trol
AUTO IMMediate "Auto" mode
SINGle BUS "Single" mode.
EXTernal EXTernal "Ext Single" and "Ext Step" mode.
Use command LFO:SWEep:MODE
to select between the two sweep
modes.
EAUTo - "Ext Start/Stop" mode.
:TRIGger<hw>:FSWeep:SOURce....................................................................................844
:TRIGger<hw>:FSWeep[:IMMediate]................................................................................844
:TRIGger<hw>:LFFSweep.............................................................................................. 845
:TRIGger<hw>:LFFSweep:SOURce.................................................................................845
:TRIGger<hw>:LFFSweep:IMMediate.............................................................................. 846
:TRIGger<hw>:PSWeep:SOURce....................................................................................846
:TRIGger<hw>:PSWeep[:IMMediate]................................................................................847
TRIGger Subsystem

Table of Contents

Other manuals for Rohde & Schwarz SMBV100A

Related product manuals