Rohde & Schwarz SMBV100A - Bert:setup:data:connector; Bert:setup:data[:Polarity]; Bler:setup:data:connector; Bler:setup:data[:Polarity]

Remote Control Commands
R&S
®
SMBV100A
538Operating Manual 1176.8016.02 ─ 17
Parameters:
<COrder> LSB | MSB
LSB
The checksum starts with the least significant byte.
MSB
The checksum starts with the most significant byte.
*RST: LSB
Example:
BLER:SET:CORD MSB
the checksum starts with the most significant byte.
Manual operation: See "CRC Order" on page 200
:BLER:SETup:DATA[:POLarity]
<Polarity>
:BERT:SETup:DATA[:POLarity] <Polarity>
Sets the polarity of the feedback data bits.
Parameters:
<Polarity> NORMal | INVerted
NORMal
High level stands for a logic 1, low level for a logic 0.
INVerted
Low level stands for a logic 1, high level for a logic 0.
*RST: NORMal
Example:
BERT:SET:DATA INV
sets inversion of data signal.
Manual operation: See "Data Polarity" on page 193
:BLER:SETup:DATA:CONNector <Connector>
:BERT:SETup:DATA:CONNector <Connector>
Selects the connector for the data input signal.
You can map the signal either to the TRIGGER, or to the MARKER 1 connector.
Parameters:
<Connector> MRK1 | TRIGger
*RST: TRIGger
Manual operation: See "Data" on page 202
BERT and BLER Subsystems