Instrument Function
R&S
®
SMBV100A
171Operating Manual 1176.8016.02 ─ 17
If the connection does not succeed, consider to check the following:
●
Is the network folder, or computer you try to map turned on?
●
Is the network folder or computer enabled for remote access?
●
Does the selected user have the necessary permissions?
5.2.8.8 Accessing the File System of the Instrument and Transferring Files from and to
the Instrument
To access files and the file system of the instrument or to use the general file manage-
ment functions such as copying and moving data, use the standard "File Manager" dia-
log.
To transfer files from and to the instruments or to exchange files, use one of the follow-
ing alternatives:
●
Connect a memory stick to one of the USB interfaces.
The instrument recognizes automatically a connected memory stick.
●
Connect the instrument to a LAN.
For information on how to set up a LAN connection, refer to Chapter 2.6, "Setting
Up a Network (LAN) Connection", on page 43.
An instrument connected to a LAN supports the standard file transfer methods from
a remote client:
– FTP (file transfer protocol)
see "To access the file system of the R&S SMBV via ftp" on page 172
– File sharing according to the SAMBA/SMB (server message block) protocol
see "To access the file system of the R&S SMBV via SMB (Samba)"
on page 173
Both file transfer methods access the folder /var/user/share.
●
Map a nework folder or a computer to an instrument connected to a LAN.
A mapped network folder is indicated as /shares/<"Local Folder">.
See Chapter 5.2.8.7, "Mapping a Network Folder", on page 169.
This section provides an introduction to this topic. For comprehensive information, refer
to the Application Note 1GP72 "Connectivity of Rohde&Schwarz Signal Generators".
General Instrument Settings
To Next Page
Loading...
