Rohde & Schwarz SMBV100A - Status Subsystem

Remote Control Commands
R&S
®
SMBV100A
817Operating Manual 1176.8016.02 ─ 17
If you change the step size, the number of steps changes accordingly. The sweep
range remains the same.
Parameters:
<Logarithmic> float
Increment: 0.01
*RST: 1
Example:
SWE:POW:STEP 10dB
sets the step width for logarithmic sweep spacing to 10 dB of the
previous level in each instance (for a level sweep).
Manual operation: See " Step - Level Sweep " on page 287
[:SOURce<hw>]:SWEep:RESet[:ALL]
Resets all active sweeps to the starting point.
Example:
SWE:RES
resets all active sweeps to the starting point.
Usage: Event
Manual operation: See " Reset Sweep " on page 266
7.17 STATus Subsystem
This system contains the commands for the status reporting system. See also Chap-
ter 6.5, "Status Reporting System", on page 494 for detailed information.
*RST on page 507 has no effect on the status registers.
Value ranges
●
Queries return the current value of the respective register, which permits a check of
the device status.
Return values: A decimal value in the range 0 to 32767 (=2
15
-1)
●
The configuration commands set the respective register thus determining which
status changes of the R&S SMBV cause the status registers to be changed.
Setting values: A decimal value in the range 0 to 32767 (=2
15
-1)
:STATus:OPERation:CONDition...................................................................................... 818
:STATus:OPERation:ENABle.......................................................................................... 818
:STATus:OPERation[:EVENt].......................................................................................... 818
:STATus:OPERation:NTRansition....................................................................................818
:STATus:OPERation:PTRansition.................................................................................... 819
:STATus:PRESet........................................................................................................... 819
:STATus:QUEStionable:CONDition..................................................................................819
:STATus:QUEStionable:ENABle...................................................................................... 819
:STATus:QUEStionable[:EVENt]......................................................................................820
STATus Subsystem