Instrument Function
R&S
®
SMBV100A
136Operating Manual 1176.8016.02 ─ 17
To access the required settings:
► Select "Setup > Environment > Date/Time" via the SETUP or MENU key.
The "Date / Time" dialog contains the time and data settings of the operating sys-
tem.
The parameters "Date" and "Time" are protected to prevent accidental changes.
To enable editing, unlock protection level 1, see Chapter 5.2.3.17, "Protection",
on page 146.
Date
Displays the date set in the operating system in the format [dd.mm.yyyy].
Remote command:
:SYSTem:DATE on page 837
Time
Displays the time set in the operating system in the format [hh.mm.ss].
The time setting corresponds to the selected Time Zone.
Remote command:
:SYSTem:TIME on page 838
Time Zone
Selects the time zone.
You can select the time zone according to the major cities on the respective conti-
nents.
Note: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE on page 838
:SYSTem:TIME:ZONE:CATalog? on page 838
5.2.3.12 Network Settings
The "Network Settings" dialog shows the parameters relevant for identifying the instru-
ment in a network. The R&S SMBV is equipped with a network interface and can be
connected to an Ethernet LAN (local area network).
How to connect the signal generator to the network is described in Chapter 2.6.1,
"Connecting the Instrument to the Network", on page 43.
General Instrument Settings
To Next Page
Loading...
