Rohde & Schwarz SMBV100A - Display;Keyboard Settings

Instrument Function
R&S
®
SMBV100A
142Operating Manual 1176.8016.02 ─ 17
"State"
Enables the automatic compensation.
Remote command:
[:SOURce]:INPut:DELay:ADCState on page 745
"Slave Position
in Chain"
Defines the position of the slave instrument in the daisy chain, where
the slave directly connected to the master instrument is the one with
number 1, etc.
Remote command:
[:SOURce]:INPut:DELay:SPOSition on page 745
"Cable Length"
Sets the total length of the cable used to connect the CLK OUT and
CLK IN connectors. For the first slave in the chain, the value repre-
sents the cable length between the master and the first slave; for the
second slave, the cable length to the first and to the second has to be
defined, etc.
Remote command:
[:SOURce]:INPut:DELay:CLENgth<ch> on page 745
5.2.3.14 Display/Keyboard Settings
In the "Display/Keyboard Settings" dialog the power-save mode and external keyboard
settings are made. It is opened using the SETUP or MENU key under "Environment".
Screen Saver Active
Activates/deactivates the screen-save mode of the display.
If activated, the display including backlight is completely switched off after the elapse of
the "Wait Time" when no entries via front panel, external mouse or external keyboard
are made.
This mode is recommended for preserving the display especially if the instrument is
exclusively operated via remote control.
Remote command:
:DISPlay:PSAVe[:STATe] on page 553
Wait Time
Enters the idle time that must elapse before the display lamp is shut off when no
entries are made.
Remote command:
:DISPlay:PSAVe:HOLDoff on page 553
Layout (USB Keyboard Settings)
Selects the keyboard layout for the selected keyboard language.
General Instrument Settings