Rohde & Schwarz SMBV100A - Marker Settings

Remote Control Commands
R&S
®
SMBV100A
661Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:DM[:TRIGger]:SEQuence <Sequence>
The command selects the trigger mode.
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
AUTO
The modulation signal is generated continuously.
RETRigger
The modulation signal is generated continuously. A trigger event
(internal or external) causes a restart.
AAUTO
The modulation signal is generated only when a trigger event
occurs. After the trigger event the signal is generated contunu-
ously. Signal generation is stopped with comman
SOUR:BB:DM:TRIG:ARM:EXEC and started again when a trig-
ger event occurs.
ARETrigger
The modulation signal is generated only when a trigger event
occurs. THe device automatically toggles to RETRIG mode.
Every subsequent trigger event causes a restart. Signal genera-
tion is stopped with comman SOUR:BB:DM:TRIG:ARM:EXEC
and started again when a trigger event occurs.
SINGle
The modulation signal is generated only when a trigger event
occurs. After the trigger event the signal is generated once to
the set sequence length (SOUR:BB:DM:TRIG:SLEN). Every
subsequent trigger event caused a restart.
*RST:
AUTO
Example:
BB:DM:SEQ AAUT
sets the "Armed_auto" trigger mode; the device waits for the first
trigger (e.g. with *TRG) and then generates the signal continu-
ously.
Manual operation: See "Trigger Mode" on page 372
Marker Settings
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:MODE......................................................661
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:OFFTime.................................................. 662
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:ONTime....................................................663
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PATTern...................................................663
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:DIVider..........................................663
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:FREQuency?................................. 664
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:MODE <Mode>
Defines the signal for the selected marker output.
SOURce Subsystem