Rohde & Schwarz SMBV100A - Block Error Rate Settings; General Settings

Instrument Function
R&S
®
SMBV100A
196Operating Manual 1176.8016.02 ─ 17
Timeout
Sets a time limit for the BER process.
Remote command:
:BERT:SETup:TIMeout on page 542
Connectors
Accesses the dialog for mapping the signals to the corresponding connectors, see
5.4.11 Block Error Rate Settings
Access:
► Select "Baseband > MISC > Block Error Rate".
The "Block Error Rate" dialog contains all the parameters to configure, activate and
evaluate the measurement.
The remote commands required to define these settings are described in Chapter 7.5,
"BERT and BLER Subsystems", on page 532.
5.4.11.1 General Settings
State............................................................................................................................197
Block Error Rate..........................................................................................................197
Received Blocks..........................................................................................................197
Bit and Block Error Rate Measurements