Instrument Function
R&S
®
SMBV100A
415Operating Manual 1176.8016.02 ─ 17
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:DELete on page 641
Shift Seg.# Up/Down
Shifts the selected segment up and down.
Blank Segment
The Blank Segment section is where a blank segment can be configured.
Clock Rate
Selects the clock rate of the blank segment.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 639
Samples
Selects the number of samples for the blank segment.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 639
Period
Displays the resulting period for the blank segment.
Remote command:
n.a.
Append Blank
Adds the blank segment to the multi segment file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
on page 639
Level / Clock /Marker
The Level/Marker/Clock section provides the parameters necessary to adjust the level,
marker and clock settings for the selected multi segment waveform file.
Level
Defines the level mode for the multi segment waveform.
"Unchanged"
Conserning the level settings, the segments are output exactly as
defined in the files. The "Level" display applies only to the segment
with the highest rms value. In some circumstances the remaining
segments are output at a lower level than that displayed.
"Equal RMS"
Segments are output so that all segments have the same rms value.
The "Level" display applies to all segments.
Baseband Signal - Baseband Block
To Next Page
Loading...
