Remote Control Commands
R&S
®
SMBV100A
534Operating Manual 1176.8016.02 ─ 17
:BERT|BLER:STORe <Filename>
Stores the current BERT/BLER settings into the selected file; the file extension is
assigned automatically.
Stored are files with extension *.ber_bler.
Setting parameters:
<Filename> string
Filename or complete file path
Usage: Setting only
:BLER:RESult?
Queries the result of the last BLER measurement. The response consists of seven
results separated by commas. In the first measurement following the start, intermediate
results for the number of data blocks, errors and error rate are also queried. In the fol-
lowing measurements (only for BLER:SEQ AUTO) only the final results of each single
measurement are queried
Note: At the end of a measurement, the restart of a new one is delayed until the first
measurement result has been queried with BLER:RES. The resulting brief measure-
ment interruption is irrelevant because the subsequent measurement will be synchron-
ized within 24 data bits.
Return values:
<NumBlock> integer
<data blocks>
Numer of checked data blocks.
<NumErrors> integer
Number of errors.
<ErrorRate> float
If no termination criterion has been reached since the beginning
of the measurement, the current quotient of "Number of errors"
and "Number of data blocks" is entered. As soon as at least one
final result has been reached in continuous measurement, the
most recent final result is entered.
<MeasFinished> integer
Status of measurement.
1 = Measurement has been terminated, i.e. the number of data
blocks or errors preset by the commands BLER:SETup:MCOunt
and BLER:SETup:MERRorhas been reached, or the measure-
ment has been stopped by the command BLER:STOP.
0 = Measurement has not been terminated.
BERT and BLER Subsystems
To Next Page
Loading...
