Instrument Function
R&S
®
SMBV100A
277Operating Manual 1176.8016.02 ─ 17
RF Frequency Sweep Settings
► To access the sweep dialog, select "RF/A Mod > configure > Sweep/List > RF Fre-
quency Sweep".
In these dialogs you can configure the corresponding sweep signal.
State - Frequency Sweep
Activates RF sweep mode.
Note:
Activating a sweep mode automatically deactivates other sweeps and the list mode.
Remote command:
[:SOURce<hw>]:FREQuency:MODE on page 738
Mode - RF Frequency Sweep
Selects the RF frequency sweep mode.
If you change the sweep mode during the execution, the signal generator stops the
sweep and starts with the next trigger event at the initial value.
The "Reset Sweep" button sets the sweep to the start value.
"Auto"
Generates a continuously repeating sweep signal immediately after
activating the sweep mode.
The sweep steps are performed atomatically, controlled by the dwell
time, see " Dwell Time - Frequency Sweep " on page 282.
Example:
SOUR:SWE:FREQ:MODE AUTO
TRIG:FSW:SOUR AUTO
SOUR:FREQ:MODE SWE
RF Block
To Next Page
Loading...
