Instrument Function
R&S
®
SMBV100A
419Operating Manual 1176.8016.02 ─ 17
The file name of the waveform file is always determined with the command [:
SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate on page 645
Create and Load
Creates a new multi segment waveform using the current table entries.
This multi segment waveform is saved with the file name specified in "Output File". As
with normal waveforms, the file extension is *.wv.
Depending on the configuration of the multi segment waveform, calculation may take
some time.
Following this the "Create Multi Segment Waveform File" submenu is closed and the
new multi segment waveform is loaded.
In remote control the configuration file to be used for the creation of the multi segment
waveform is defined with the command:[:SOURce<hw>]:BB:ARBitrary:
WSEGment:CREate or [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad.
The file name of the waveform file is always determined with the command [:
SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad on page 638
Multi Segment Waveform Sequencing
The settings provided in the "Multi Segment Waveform Sequencing" dialog can be
adjusted to crate a “play list”, i.e. to define the sequence in which the waveform file
segments are processed and how many times each of them is repeated. The config-
ured play list is displayed in form of a "Sequencing Graphic".
All segments in a “play list” must have the same clock rate.
In the "ARB" main dialog or in the "ARB Trigger/Marker/Clock" dialog, set the "Next
Segment Mode" to "Sequencer" to activate the configured “play list”.
Baseband Signal - Baseband Block
To Next Page
Loading...
