Preparing for Use
R&S
®
SMBV100A
30Operating Manual 1176.8016.02 ─ 17
●
Firmware update
Further USB interface type A are available on the front panel.
See also Chapter 2.4.1, "Connecting USB Devices", on page 40.
DIGITAL IQ IN/OUT
Connector for the input/output of a digital I/Q signal from/to an R&S instrument, like a
signal generator, analyzer or the R&S EX-IQ-BOX. The interface requires option
R&S SMBV-K18, Digital Baseband Connectivity.
LAN CONNECTOR
Ethernet interface
●
For integrating signal generators in a network
●
Remote control of signal generator
●
Remote access to the signal generator
●
Firmware update
See also:
●
Chapter 2.6, "Setting Up a Network (LAN) Connection", on page 43
●
chapter "Remote Control Basics" in the Operating Manual
HARD DISC
With respect to security concerns the hard disk can be removed from the instrument,
but it is bound to the specific R&S SMBV. Therefore it cannot be changed between dif-
ferent instruments.
NOTICE! Risk of instrument damage and data loss!. During operation the instrument is
accessing the hard disk. Removing the hard disk while operating will lead to data loss
or even instrument damage.
Do not remove the hard disk during operation.
CLOCK OUT
Output for internal clock signal.
While working in synchronous master\-slave mode, the system clock is output on this
connector.
CLOCK IN
Input for the external (symbol) clock signal for synchronizing the external data signal
and working in synchronous master-slave mode.
NEXT
This trigger input indicates the next (i.e. the 2nd, 3rd, 4th, ...) segment of a multi seg-
ment waveform, which can be a compound of e.g. a sine, a rectangular, or a sawtooth
signal.
TRIGGER
Input for external triggering of digital modulations and standards and ARB and the
external trigger in synchronous master\slave mode.
Rear Panel Tour
To Next Page
Loading...
