Remote Control Commands
R&S
®
SMBV100A
510Operating Manual 1176.8016.02 ─ 17
Example: Presets all instruments settings that are not related to the signal
path
Usage: Event
:SOURce<hw>:PRESet
Presets all parameters which are related to the selected signal path.
The following functions are only preset by command *RST: Fading, transient recorder.
Example:
SOUR:PRES
Presets all settings that are related to signal path
Usage: Event
:SYSTem:PRESet
Triggers an instrument reset. It has the same effect as:
●
The PRESET key
●
The *RST command
For an overview of the settings affected by the preset function, see Chapter 5.2.2,
"Default Instrument Settings - Preset Key", on page 118.
Example:
SYST:PRES
All instrument settings (also the settings that are not currently
active) are reset to their default values.
Usage: Setting only
:SYSTem:FPReset
Triggers an instrument reset to the original state of delivery.
Note: "Factory Preset" resets the "Remote Channel" and network settings to the
default values.
Executing "Factory Preset" via remote control terminates the connection to the instru-
ment, if these settings had been configured to values different to the default ones.
The factory preset function resets nearly all instrument settings. In addition to the regu-
lar preset by means of the PRESET key, a "Factory Preset" resets also the following
values:
●
Reference frequency settings ("Ref Oscillator" menu)
●
Power on settings ("Level/EMF" menu)
●
Network settings including hostname ("Setup" menu)
●
Remote channel settings including GPIB address ("Setup" menu)
●
Start/Stop display update ("Setup" menu)
●
Display and keyboard settings ("Setup" menu).
Preset Commands
To Next Page
Loading...
