Rohde & Schwarz SMBV100A - Page 585

Remote Control Commands
R&S
®
SMBV100A
570Operating Manual 1176.8016.02 ─ 17
Example:
MMEMory:DATA '/var/user/test.txt',#15hallo
Writes the block data to the file test.txt.
The digit 1 indicates a length entry of one digit; the digit 5 indi-
cate a length of the binary data (hallo) in bytes.
MMEMory:DATA? '/var/user/test.txt'
Sends the data of the file test.txt from the instrument to the
controller in the form of a binary block.
Response: #15hallo
Usage: SCPI confirmed
:MMEMory:DATA:UNPRotected
<Msus>, <Data>
The setting command sends the I/Q data and the marker data to the file defined with
the <Msus> parameter. The required tags are created automatically so that the file
content follows the waveform file format.
The query reads out the I/Q data part or the marker information of the specified file.
Waveform files can also be created with the command [:SOURce<hw>]:BB:
ARBitrary:WAVeform:DATA. In this case, the complete content of the waveform file
must be specified, i.e. not only the I/Q or marker data but all required tags.
Parameters:
<Msus> <Identifier>:<file name>
Mass Storage Unit Specifier
A string that specifies whether I/Q data (NVWFM) or marker data
(NVMKR) is transferred and the file name the data is stored in.
If the file with the specified name does not exist, a file is created.
Any existing content in the file is overwritten.
Complete file path and file extension may also be specified. If
omitted, files are stored in the default directory and the exten-
sion *.wv is assigned to the file name.
MMEMory Subsystem