Preparing for Use
R&S
®
SMBV100A
50Operating Manual 1176.8016.02 ─ 17
3. Double click on the setup file to start the installation.
The setup wizard leads through the installation. This description focus only on the
relevant settings.
a) Select installation of all components.
b) In the "Additional Task Panel", enable all entries.
A successful installation is indicated by a message.
At the same time a warning is displayed stating that a password must be set.
4. Select "OK".
The "Default Local System Properties" panel opens.
Remote Access via an External Controller
To Next Page
Loading...
