Remote Control Commands
R&S
®
SMBV100A
677Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:DM:CLISt:DATA <Data>
Sends the data to the currently selected control list. If the list already contains data, it is
overwritten. This command only writes data into the data section of the file.
The values for the control signals are sent, arranged in an 8-bit value as follows:
Signal Order Decimal value of bits
Marker 1
Marker 2
LSBit 1
2
Burst = LSBit 16
LevAtt1 LSBit 32
CWMod LSBit 64
Hop MSBit 128
You can also send the data as a binary block. Each binary block is a 2-byte value in
which the 16 bits represent the binary values (16-bit unsigned integer, 2 bytes, LSB
first).
When binary data transmission is in use, you can use the com-
mand :SYSTem:COMMunicate:GPIB:LTERminator EOI to set the termination
character mode to ‘EOI control data message only’. Then, a random LF in the data
sequence is not interpreted as end, i.e. prematurely terminating the data transmission.
The command ...LTER STANdard resets the mode.
For query purposes, the command :FORMat ASCii | PACKed can be used to
switch between the formats. The byte sequence is defined in the IEC bus standard as
'most significant byte first'
Note: C-Lists are created in binary format. However, if you need the C-List in ASCII
format, e.g. for creating a waveform file with R&S WinIQSIM2, see the example in
Chapter 7.4.4, "Creating an ASCII C-List Manually", on page 530.
*RST has no effect on data lists. This command is without query.
Setting parameters:
<Data> string
Example:
BB:DM:CLIS:SEL 'c_list1'
Selects the control list.
BB:DM:CLIS:DATA 0,0,0,0,8,8,8,0,0,0,0...
Enters the control values in list c_list1. In the example, only
ramps for marker 4 are set.
Usage: Setting only
Manual operation: See "Edit Control List" on page 366
SOURce Subsystem
To Next Page
Loading...
