Remote Control Commands
R&S
®
SMBV100A
790Operating Manual 1176.8016.02 ─ 17
Parameters:
<Amplitude> float
Minimum level ... Maximum level
The value range for the level setting varies according to the
instrument model.
The values are given in the data sheet.
Increment: 0.01
*RST: n.a. (factory preset: 30)
Example:
SOURce:POWer:LIMit:AMPLitude 10
or
:POW:LIM 10
limits the RF level to maximum +10 dBm.
Manual operation: See " Limit - RF Level " on page 223
[:SOURce<hw>]:POWer:LMODe
<LevMode>
Sets the RF level mode.
Parameters:
<LevMode> NORMal | LOWNoise | LOWDistortion
NORMal
The RF signal is output in the standard values of the instrument.
LOWNoise
A very low noise sinewave signal is output.
LOWDistortion
A very pure sinewave signal is output.
*RST: NORMal
Example:
POW:LMODE LOWD
sets the LOWDistortion mode. The instrument reduces distor-
tions of the RF signal to a minimum.
Manual operation: See " RF Mode " on page 222
[:SOURce<hw>]:POWer:MANual <Manual>
In Sweep mode (:SOUR:POW:MODE SWE) the command sets the level for the next
sweep step in the Step sweep mode (:SOUR:SWE:POW:MODE MAN). Here only level
values between the settings [:SOUR]:POW:STAR and [:SOUR]:POW:STOP are per-
mitted. Each sweep step is triggered by a separate :SOUR:POW:MAN command.
As with the "Level" value entered in the "RF Level" menu, the OFFSet value is also
taken into consideration with this command.
The specified value range is therefore only effective if :SOURce:POWer:OFFSet is set
to 0. The value range for other OFFset values can be calculated using the following
formula:
Minimum level + OFFSet ... Maximum level + OFFSet
SOURce Subsystem
To Next Page
Loading...
