The NTP Servers and NTP Peers Panels
The NTP Servers and NTP Peers panels display which servers in the network are
set up at higher or equal Stratums (Servers or Peers, respectively), and their con-
figurations. These panels are also used to add, configure, or remove NTP Servers
and Peers.
Note: For information on how to view NTP Clients, see "Viewing NTP
Clients" on page113.
The NTP Servers and NTP Peers panels are part of the NTP Setup screen (see
"The NTP Setup Screen" on page109), which can be accessed via
MANAGEMENT > NETWORK: NTP Setup.
Information provided in the NTP Servers and NTP Peers panels
The following columns are used to break down the status information for recog-
nized NTP Servers and NTP Peers.
Note: Servers will be displayed in the Status view only if they can be
resolved. They will, however, always be displayed in the Setup view
in order to reconfigure them, if necessary.
IP/HOST: Name and real-time status (color-coded)
REF ID: Identifies the type of Input REFerence e.g., GPS indicates the ref-
erence can use GPS for its synchronization. Below is a list of potential REF
IDs reported by the VersaSync Timing System (otherNTP Servers and
Peers may report different references):
GPS: GNSS reference
IRIG: IRIG reference
HVQ: HAVE QUICK reference
FREQ: Frequency reference
PPS: External 1PPS reference
PTP: PTP reference
120
CHAPTER 2 • VersaSync User Manual Rev. 12
2.8 Configuring Network Settings
To Next Page
Loading...
