Note: Turning BroadShield OFF and Auto Sync Control ON is
an invalid setting and will cause a "Failed to connect to the
unit..." error.
3. In the BroadShield Web UI on the right, navigate to SETTINGS >
ALGORITHMS, and ensure that Jamming and/or Spoofing detection are
enabled.
Configuring BroadShield
To configure BroadShield:
1. Navigate to TOOLS: SYSTEM > Broadshield. The embedded Broadshield
Web UI will open. If you cannot enable Broadshield from this screen, this
license is not present.
2. Click SETTINGS to open the following sub-menus:
BROADSIGHT
BroadSight is a service that allows collection of data from multiple BroadShield
units and provides a dashboard view of the data.
Note: BroadSight for VersaSync is currently not supported.
HOME BASE
3.3 Managing References
CHAPTER 3 • VersaSync User Manual Rev. 12
187
To Next Page
Loading...
