Command Description
resetpw Resets the administrator account (spadmin) password back to the
default value “
admin123
”
routes4 Displays the current IPv4 routing table(s)
routes6 Displays the current IPv6 routing table(s)
rt4add Adds an IPv4 static route
rt4del Deletes an IPv4 static route
rt4get Displays the configured IPv4 static routes
rt6add Adds an IPv6 static route
rt6del Deletes an IPv6 static route
rt6get Displays the configured IPv6 static routes
runtime Displays the current runtime length
saveconf Generate archive of current configuration
savelog Generate archive of all log files
scaleget Displays configured system timescale
scaleset Used to configure the system timescale
sendnmeaudp Used to configure, enable and disable the NMEA over UDPfeature
(see
"System Time Message" on page107
for more information)
sendtrap Triggers one type of a possible set of alarms.
sendtrap all Sends one instance of all alarms
services Displays the state of services (enabled/disabled)
servget Displays the state of individual services
servset Enable or disable specific services
slaacget Displays whether SLAAC is enabled
slaacset Used to enable or disable SLAAC
stateset Enable or disable an entry in the reference priority table. index = 0...15.
state = 0 (disable), 1 (enable)
status Displays information about the oscillator disciplining
swupgrade Performs system upgrade using the update bundle provided
syncstate Display timing system synchronization state
To Next Page
Loading...
