Command Description
options Displays configured options installed (if any)
oscget Displays the installed system oscillator
portget Display whether network port is enabled (for example, "portget
ETH2")
portset Enable or disable a network port:
"portset x on" where "x" is the port number (for example, "ETH2")
"portset X off"
portstate Display the current state for a network port
ppsctrl Enable/disable individual 1PPS output signals
priorset Sets the priority of an entry in the reference priority table
ptpcfgload Copies specified file to PTP config location.
ptpifaceset Enable or disable PTPon a specified interface.
ptpifacesetcfg Set the configuration of a specified interface from a file.
radius setretry <value> Sets how many radius login retries will be attempted
radius getretry <value> Gets the number of radius login retry attempts
radius server list Lists radius servers
radius
server
add
<host>
<port>
<key>
<timeout>
Adds radius server
radius server del <id> Deletes radius server number <id>
rbxostatus check For mRO-50 rubidium oscillators, returns INVALID if standby power
has been lost and the oscillator state has been compromised.
rbxostatus reset For mRO-50 rubidium oscillators, resets INVALID flag to VALID.
reboot Used to warm-boot the unit without having to disconnect or recon-
nect power
reftable Displays reference priority table
release4 Used with DHCP to release the IPv4 address
release6 Used with DHCPv6 to release the IPv6 address
renew4 Used with DHCP to renew the assigned IPv4 address
renew6 Used with DHCPv6 to renew the assigned IPv6 address
To Next Page
Loading...
