MM Minutes (00-59)
: Colon separator
SS (00-60)
. Decimal separator
SSS Milliseconds (000-999)
L Leap Second indicator (space, L)
D Daylight Saving Time Indicator (S,I,D,O)
The leading edge of the first character (CR) marks the on-time point of the data
stream.
The time synchronization status character (I) is defined as described below:
? When the receiver is unable to track any satellites and the time synchronization lamp is
red.
* When the receiver time is derived from the battery backed clock or set manually through
the Setup Port Interface.
The quality indicator (Q) provides an inaccuracy estimate of the output data
stream. When the receiver is unable to track any GNSS satellites, a timer is star-
ted. "Quality indicators" below lists the quality indicators and the corresponding
error estimates based upon the GNSS receiver 1PPS stability, and the time
elapsed tracking no satellites. The Tracking Zero Satellites timer and the quality
indicator reset when the receiver reacquires a satellite.
Quality
Time
(hours)
TXCO Error (mil-
liseconds)
OCXO Error
(milliseconds)
Rubidium Error
(microseconds)
Space Lock <1 <0.01 <0.3
A <10 <10 <0.72 <1.8
B <100 <100 <7.2 <18
C <500 <500 <36 <90
D >500 >500 >36 >90
Table 5-31:
Quality indicators
The leap second indicator (L) is defined as:
(Space) When a leap second correction is not scheduled for the end of the month.
L When a leap second correction is scheduled for the end of the month.
The Daylight Saving Time indicator (D) is defined as:
352 VersaSync User Manual
APPENDIX
To Next Page
Loading...
