Samsung OfficeServ 7000 Series - Page 455

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-417
(Continued)
No Code Alarm Name Definition
80 MJE05 MGI NTWK Rec The MGI card has restarted because the system detects
the card does respond via network link.
External ping test.
Alarm Data = Cabinet, Slot (Cx-Syy)
81 MJE06 MGI DSP Error The MGI card DSP has blocked because the system
detects the card DSP does not run correctly.
Alarm Data = Cabinet, Slot (Cx-Syy-Pzz)
82 MJE07 MGI DSP Run The MGI card DSP has restarted because the system
detects the card DSP runs correctly.
Alarm Data = Cabinet, Slot (Cx-Syy-Pzz)
83 MJE08 WBS Disconnect Indicates the WBS is disconnected.
Alarm Data = CWBS:xx or BWBS:xx
84 MJE09 WBS connect Indicates the WBS is connected.
Alarm Data = CWBS:xx or BWBS:xx
85 MJE10 SVMi Restart SVMi Restart
86 MJE11
SVMi Halt Whether to halt the SVMi card
87 MJE12
SVMi Down Whether to shut down the SVMi card
88 MJE13 MGI Self Restart MGI Self Restart
89 MJE14 MPS Restart MPS module Restart
90 MJE15 MPS Stop MPS module Stop
-
MJE16 OAS NTWK Error OAS Network Error
-
MJE17
OAS NTWK
Recovery
OAS Network Recovery
-
MJE18 OAS IP CONFLICT OAS IP CONFLICT
- MJE19 OAS IP Recovery OAS IP Recovery
-
MJE20 OAS Start OAS CARD START
- MJE21 OAS Stop OAS CARD STOP
-
MJE22 OAS Link Down OAS CARD LINK DOWN
-
MJE23 OAS Link Recover OAS CARD LINK RECOVERY
- MNF-- Minor Error Minor Fault with Alarm Buffer saving
91 MNF01 Card Out A circuit card mounted in a universal slot has been
removed from service or is not recognized by the system.
Alarm Data = Cabinet, Slot (Cx-Syy)
92 MNF02 Card In A circuit card mounted in a universal slot has been
returned to service.
Alarm Data = Cabinet, Slot (Cx-Syy)
94 MNF04 Trunk Fault Out of service trunk detected via loop detect. Internal
CODEC test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)