SATO CL4NX Plus - Page 231

231
[Every Page]
Perform the head check for each specified number of media.
Appears if you have selected [Every Page] in the [Head Check Mode] menu.
The setting range is from 1 to 999999.
[Check Media Size]
Enable or disable media size check.
Appears if you have selected [Gap] or [I-Mark] in the [Sensor Type] menu.
If this function is enabled, "Media Error" is shown when either of the following conditions applies:
• If the media is more than 3 mm (0.12") longer than the media length specified with the media size
command ESC+A1.
• If the current media feed length is more than 3 mm (0.12") longer than the media length fed for
the first time after this function is enabled.
The options are as follows:
Enabled
Enable media size check.