Operations in Linerless Mode
586
Operations in Linerless Mode
Operation 39: Linerless Mode, Backfeed Before Printing, and Without Pulse Input
(Head Check Disabled)
Operation
*1 The dispenser sensor confirms the dispensing condition and the product does not perform the next
operation until the label is dispensed.
*2 The backfeed speed becomes 2 inches/sec immediately after powering on the product, immediately
after backing from the sleep mode, or after 60 minutes or more from the last printing.
• The figure above shows the reference position when the I-mark sensor is used.
To Next Page
Loading...
