Print Mode
96
Print Mode
You can change the print mode of the product according to its usage and installed options.
The product has the following print modes:
[Continuous]
Prints the specified number of media. The media remains in position for printing at all times.
[Tear-Off] (Feeding media to the position for manual cutting)
After printing the specified number of media, the product feeds the last printed media so that it
is fully extended out of the product’s front for removal. After printing, tear off the media manually.
The media will be back to the print head position to start the next printing.
[Cutter]
Cuts each media while printing the specified number of media. You can specify this option if you
have installed the cutter unit.
[Cut & Print]
Allows you to continuously print and cut at the specified media repeat. If no print data is received
within the period specified for [Eject Cut], the product will feed the media to the cut position and
cut the last printed media. You can specify this option if you have installed the cutter unit.
[Dispenser]
Peels the liner from the printed label as the label is fed to the product’s front. Once the printed
label has been removed from the product for application, the next label will retract and position
itself for printing. You can specify this option if you have installed the dispenser unit.
[Linerless]
Cuts each label while printing the specified number of labels. You can specify this option if you
have installed the linerless cutter kit.
• You cannot set the [Print Mode] if [Auto-mode] is [Enabled].
Change the print mode according to the following procedure:
To Next Page
Loading...
