SATO CL4NX Plus - [Applications] Menu

[Applications] Menu
668
Setting Item Initial
Value
User
Reset
Factory
Reset
[EXT 9PIN] MODE1 Yes/
Interface
Yes/
Interface
[EXT Mode] TYPE4 Yes/
Interface
Yes/
Interface
[Inputs]
[Start Print] PIN 5 Yes/
Interface
Yes/
Interface
[Reprint] PIN 7 Yes/
Interface
Yes/
Interface
[Outputs]
[Paper End] PIN 1 Yes/
Interface
Yes/
Interface
[Ribbon End] PIN 3 Yes/
Interface
Yes/
Interface
[Machine Error] PIN 4 Yes/
Interface
Yes/
Interface
[Print Done] PIN 6 Yes/
Interface
Yes/
Interface
[Offline]/[Qty] PIN 9 Yes/
Interface
Yes/
Interface
[Ribbon Near End] PIN 10 Yes/
Interface
Yes/
Interface
[Dispenser] OFF Yes/
Interface
Yes/
Interface
[Label Near End] OFF Yes/
Interface
Yes/
Interface
[EXT I/O Re-print] Disabled Yes/
Interface
Yes/
Interface
[Applications] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.