SATO CL4NX Plus - Adjusting the Print Speed

611
Adjusting the Print Speed
The adjustment of the print speed not only changes the speed of printing but also affects the print
quality.
The setting range of the print speed varies depending on the following print resolution:
Resolution CL4NX Plus
203 dpi
(8 dots/mm)
305 dpi
(12 dots/mm)
2 to 14 ips (inches/sec) (50.8 to 355.6 mm/sec)
609 dpi
(24 dots/mm)
2 to 6 (inches/sec) (50.8 to 152 mm/sec)
• When the [Printing] > [Advanced] > [Prioritize] menu has been set to [Commands] and
the print speed is specified by command, the data will be printed with the print speed
specified by the command.
• While the print job is paused, the [Adjustments] menu will appear instead of the
[Settings] menu and you can adjust the print speed.
• If the optional linerless cutter kit is installed to CL4NX Plus, the setting range is 2 to 6
(inches/sec) (50.8 to 152 mm/sec) regardless of the printing resolution.
1.
When the product is in Online mode, press the button to change to Offline
mode.
2.
Press the button to show the [Settings] menu.