SATO CL4NX Plus - [Interface] Menu

[Interface] Menu
656
Setting Item Initial Value User
Reset
Factory
Reset
[Label Near End] Disabled Yes Yes
1
Auto-calibration is not available for linerless models.
[Interface] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
Setting Item Initial
Value
User
Reset
Factory
Reset
[Network]
[Settings]
[LAN]
[IPv4]
[Mode] DHCP Yes/
Interface
Yes/
Interface
[DHCP] - - -
[IP Address] 0.0.0.0 Yes/
Interface
Yes/
Interface
[Netmask] 255.255.255.0Yes/
Interface
Yes/
Interface
[Gateway] 0.0.0.0 Yes/
Interface
Yes/
Interface
[DNS] 0.0.0.0 Yes/
Interface
Yes/
Interface
[IPv6]
[Mode] Disable Yes/
Interface
Yes/
Interface
[DHCP] - - -
[IP Address] :: Yes/
Interface
Yes/
Interface