SATO CL4NX Plus - Page 655

655
Setting Item Initial Value User
Reset
Factory
Reset
[Vertical] 0 dot Yes Yes
[Horizontal] 0 dot Yes Yes
[Advanced]
[Calibrate]
[Auto-calibration]
1 Gap + I-Mark - -
[GAP Levels] Value adjusted by the factory. No No
[GAP Slice Level] Auto No No
[I-Mark Levels] Value adjusted by the factory. No No
[I-Mark Slice Level] Auto No No
[Head Check] Off Yes Yes
[Head Check Mode] Always Yes Yes
[Every Page] 1 Yes Yes
[Check Media Size] Disabled Yes Yes
[Adjustments]
[Offset] 0 dot No No
[Pitch] 0 dot No No
[Pitch Offset] 0 dot No No
[Darkness Adjust] 50 No No
[Start Online] Enabled Yes Yes
[Feed After Error] Disabled Yes Yes
[Feed At Power On] Disabled Yes Yes
[Finisher Feed] 0 dot (Standard) Yes Yes
[Paper End] Using I-mark Yes Yes
[Head Base Position] Standard Yes Yes
[Prioritize] Commands Yes Yes
[Reprint] Disabled Yes Yes
[Print End Position] 0 dot Yes Yes