SATO CL4NX Plus - Page 654

[Printing] Menu
654
Setting Item Initial Value User
Reset
Factory
Reset
Linerless mode
4 ips
[Sensor Type] Gap
None (When [Print Mode] is
[Linerless])
Yes Yes
[Micro Label Print Mode]
[Micro Label Print Mode] Disable Yes Yes
[Auto Label Length Detection] Enable Yes Yes
[Label Length Averaging Count] 3 Yes Yes
[Label Length]
203 dpi
320 dots
305 dpi
480 dots
609 dpi
960 dots
Yes Yes
[Auto-mode] Enabled Yes Yes
[Print Mode] Tear-Off (If no option is installed)
Cutter (If cutter unit is installed)
Dispenser (If dispenser unit is
installed)
Linerless (If linerless cutter kit is
installed)
Yes Yes
[Backfeed] Before (If [Print Mode] is set to
[Tear-Off] or [Linerless])
After (If [Print Mode] is set to
[Dispenser], [Cutter] or [Cut &
Print])
None (If [Print Mode] is set to
[Continuous])
Yes Yes
[Eject Cut] Off Yes Yes
[Darkness Range] A Yes Yes
[Darkness] 5 Yes Yes
[Imaging]