Select a Safe Location
16
Precautions for Installation and Handling
Select a Safe Location
Product operations can be affected by the product's environment.
Refer to the following instructions regarding how to install and handle the product.
• Place the product on a surface that is flat and level.
If the surface is not flat and level, this may cause bad print quality. This may also cause a
malfunction and decrease the life span of the product.
• Do not place the product in a location that is subject to vibration.
Subjecting the product to severe vibration or shock may cause a failure or damage to the
product, leading to a product malfunction.
• Keep the product out of high temperature and humidity.
Avoid locations subject to extreme or fast changes in temperature or humidity.
• Do not install the product in a location exposed to water or oil.
Water or oil entering inside the product may cause a fire, electric shock or malfunction.
• Avoid dust.
Dust build up may cause lowered print quality, faults, or malfunctions.
• Keep out of direct sunlight.
The product has a built-in optical sensor. Exposure to direct sunlight may cause incorrect
detection by the sensor so the product does not operate normally. Therefore, close the cover
when using the product.
• Do not use in hazardous locations.
Do not use in a potentially explosive environment or atmosphere. Doing so could cause a fire or
explosion.
To Next Page
Loading...
